For small holes up to roughly ½” you may merely use spackling compound and a putty knife. For deeper or bigger holes, drywall repair kits are sold that often embody both simple metal clips that help a replacement piece or some kind of backerboard that inserts into the outlet and suspends itself in place whilst you cover it with joint compound. Embed the tape and cover the entire area with a thin coat of drywall compound, and complete the restore as described in the steps above.

And use a curler when priming to assist elevate the surface texture to match the surrounding wall. In any other case the topcoat will absorb into the patch and make the area look completely different from the encompassing paint. As well as, minimize away any paper tears with a pointy utility knife. Upon opening a door, the knob can bang up against the wall, causing injury over time.

Cover all the patch with joint compound till the strains are camouflaged, feathering the sides. Then there are two ways to repair nail pops: use a screwdriver or hammer to drive the nail back into the studs (image 1), then bracket every nail head with carefully spaced drywall screws (picture 2); or, take away the nail and drive a screw as a substitute, along with a second screw nearby, to re-safe the drywall to the stud.

Let it dry, then apply extra drywall compound, feathering the perimeters as you go. Like we did for the patches we mentioned earlier, it would take several coats, in addition to a lightweight sanding, between each coat. Attempt to avoid widespread drywall installation mistakes. Place drywall piece over the damaged space (image 1) and trace round it with a pencil (picture 2). Use a drywall or reciprocating noticed to cut out the realm throughout the traced traces (image 3). Cut two pieces of 2×4 slightly larger than the outlet.

In general, so long as the hole may be lined with what handymen refer to as a “patch,” the repair shall be a flat price. Drywall injury can vary from small cracks to massive holes, but most repairs are simple and cheap to repair. Now it’s time to minimize a patch. Professionals will take the time to sand down the perimeters across the space the place the compound was applied and the wall meets it. This can create the most seamless-trying end.